Question: Can I use WD40 to clean my motorcycle chain?

Is WD-40 good for cleaning motorcycle chains?

What can you use to clean your motorbike chain? WD-40® Specialist® Motorcycle Chain Cleaner is specifically designed for the removal of dirt, debris and old protecting products from motorbike chains. The formula will soften and solubilise all grease and oils to lift the contaminants with ease.

What can I use to clean my motorcycle chain?

To clean, some folks swear by kerosene, some WD-40. Some riders use a dedicated branded chain cleaner. Some use a grunge brush and some simply spray the chain down. As far as lubrication goes, some prefer a drier wax lube, some prefer to use the sticky blue stuff, and yet others use gear oil in a squirt bottle.

Why is WD40 bad for bike chains?

WD40 is primarily a solvent, which means that it dissolves contaminates so parts get nice and clean. As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all.

Is WD40 bad for O-ring chains?

WD-40 is great for cleaning your o-ring chain. Spray on, wipe off with rag as you go… chain is clean. Then apply silicone spray or chain lube of your choice.

IT IS IMPORTANT:  You asked: Do you pay taxes on a motorcycle?

Can I use degreaser to clean motorcycle chain?

Use Kero to clean the chain. The engine degreaser could affect the o-rings in a less than positive way. Do lube up the chain after its been cleaned. I personally brush on 90w gear oil, but you could use a motorcycle specific chain lube if so inclined.

What should you not use WD-40 on?

But Don’t Spray It On:

  • Door hinges. Sure, WD-40 will stop the squeaking, but it also attracts dust and dirt. …
  • Bike chains. WD-40 can cause dirt and dust to stick to a chain. …
  • Paintball guns. WD-40 can melt the seals in the guns.
  • Locks. …
  • iPods and iPads.

What do you lubricate O rings with?

What lubricant is best for o rings? Silicone lubricant grease. Protective, waterproof, simple to use. As o rings are made from synthetic rubbers such as Neoprene, nitrile, and EPDM, you can use petroleum grease to perfectly lubricate the o ring.

Do you need to oil an O ring chain?

Same thing goes for O-ring/X-ring chains; they need to be properly cleaned and anointed with lubrication if you expect them to resist premature stretching and fight off high wear fatigue. … The original chain grease can be replaced by brand new grease (i.e. chain lube) between the pins & bushings.