Your question: Where do you clamp a bike stand?

Is it OK to hang bike from dropper post?

Never, never NEVER, lift your bike or hang it by the seat when the dropper is sagged below the upper position. … By lifting or hanging your bike by the seat you are running the risk of having premature wear in the seals and internals which can also cause suspensioning of your dropper.

How do I turn my bike into a stationary bike?

You can use this until the weather is good enough for riding outdoors again. There are two types of stationary bike stands: a trainer, which clamps the back wheel of the bicycle while the front wheel stays on and is able to move, or a roller bike stand, which elevates the bike, allowing both wheels to spin.

Is it OK to leave bike in bike stand?

There is totally no possible way that a bike hanging in a workstand could ever possibly damage the seatpost or any other part of the bike. Same with hanging a bike by the wheels. Absolutely no reason to worry.

How do I choose a seatpost clamp?

Note: The seat clamp diameter needs to match the diameter of your seat tube rather than your seatpost, which is a little smaller. For example, a 27.2mm seatpost (a size commonly found on road bikes) fits inside a 28.6mm diameter seat tube, so it’s a 28.6mm clamp you need.

IT IS IMPORTANT:  Can you drive a dirt bike in a neighborhood?

Can you clamp a carbon bike?

You can hold the bike by the carbon post if it’s round and you clamp it gently, but you may scratch it unless you’re very careful and the jaws of the repair stand clamp are safe (keep them clean of dirt and wrap a piece of wax paper around the seatpost to help prevent scratches).

Will trek repaint my bike?

So the Trek warranty allows them to replace parts of the bike with any part / any color they choose. Yes, especially when the bike is old enough and they may not have the parts in your color or exact specification.

How do you touch up paint on a carbon bike frame?

Touching up carbon chips can be as simple as dabbing on some clear nail polish. Nail polish is cheap, includes a brush built-into the cap, and it dries fast, too. It will nicely touch up clear coats over natural carbon frames.