Your question: Are belt drive bicycles any good?

Are belt drive bikes worth it?

Belt drives are superior to chain drives in many aspects. They are easier to clean and maintain, last longer, and are quieter and smoother as well. However, they are also more expensive, which raises the overall price of the bikes who have them integrated.

Do belt driven bikes have gears?

Made from carbon fibre, belt-drive bikes work similarly to a chain – the crank drives the belt and turns the rear wheel. The difference is that belts can’t shift between cogs like a chain – they have an internal hub gearing system instead.

Do belt drive bikes make noise?

The belt can make noise when forced to run hard against the flanges on the sprockets. … Spraying water on the belt may quiet the drive for a few minutes, but the permanent solution is to correct the alignment or replace the damaged components. Another possible source of noise is a loose front sprocket.

How long does a bike belt last?

But even veteran enthusiasts can make the mistake of forgetting to look after their bike’s drive belt, which is strong, stretch-resistant and made from tensile cords. Because a drive belt can last up to 100,000 miles before needing replacement, riders may lose track of this important part of motorcycle maintenance.

IT IS IMPORTANT:  Question: Which is the left pedal on a bike?

Why use a chain over a belt?

Belt drive systems also run much smoother, with much less jerks as compared to chain drives, and produce incomparably less noise too. … Secondly, the power loss during the transmission, depending on how the system has been set-up, ranges anywhere from 9 to 15 percent, which is quite high compared to a chain drive system.

Which is stronger belt or chain?

One difference is that chain drives are simply stronger: they can lift more than a belt drive. This makes them the choice for moving heavier doors, so consider them if you’re going with a steel carriage. … Chain drives have the strength to lift a two car and three car garages without any trouble.

Which is more efficient chain or belt?

A worn chain drive is about 4% less efficient than a worn belt drive. Testing shows that Gates Carbon Drive belts are the clear winner when you measure the efficiency of a worn belt to a worn chain. Gates belts keep their efficiency over time, while chains continually lose efficiency. This is because chains stretch.

How long do Gates belts last?

You can expect a regularly cleaned belt drivetrain to last upwards of 30,000km/19,000mi. Additionally, belts will not rust if they get wet regularly (or are subject to salt near the beach).

How efficient are belts?

At the time of installation, V-belts have 95% to 98% peak efficiency. Pulley size, driven torque, under or over-belting, and V-belt design and construction impact efficiency. V-belts have a nominal efficiency of 93%, a reduction of 5%, over time if slippage occurs because the belt is not periodically re-tensioned.

IT IS IMPORTANT:  Quick Answer: How do I choose a cycling jersey?

What are the advantages of belt drive?

The advantages of a belt drive include:

  • Belt drives are cost-effective. …
  • They are simple to use.
  • Belt drives do not require parallel shaft.
  • They have a low maintenance cost.
  • They come with overload and jam protection.
  • Different speeds can be obtained by means of step or tapered pulleys.

How does a belt drive bike shift?

A belt drive requires a split frame that can be unbolted in the back in order to slide the unbreakable belt over the front and rear cogs. A belt can’t be broken and reconnected like a traditional chain, and it doesn’t shift gears in the same way—an internal shifting hub is required. (Available now.)