Frequent question: What should I lubricate my mountain bike with?

Can I use WD40 on my mountain bike?

Can I Use WD40 on my MTB Chain? Can I use WD-40 to lube my bicycle chain? No. You should never use WD40 as chain lubricant since WD-40 is NOT a true lubricant since it’s primary use is as a solvent or rust dissolver.

Can you use Vaseline on bike pedals?

You can use Vaseline to grease bike pedals. If you ride professionally or do a great deal of riding on difficult terrain, it may not be the best idea. … But otherwise, it should be just fine to use Vaseline in place of traditional grease.

What should you not use WD-40 on?

But Don’t Spray It On:

  • Door hinges. Sure, WD-40 will stop the squeaking, but it also attracts dust and dirt. …
  • Bike chains. WD-40 can cause dirt and dust to stick to a chain. …
  • Paintball guns. WD-40 can melt the seals in the guns.
  • Locks. …
  • iPods and iPads.

Can I use olive oil to lube my bike chain?

Reduces Chain Friction

Olive oils are efficient as lubricants because they perform the most basic function of eliminating chain friction and preventing chain dryness. And the oil does so quite effectively. … A lubricated bike chain, even if it is done with olive oil, is always better performing than a dry one!

IT IS IMPORTANT:  Can I use a dirt bike helmet on the street?

Can I use wd40 to grease bike pedals?

Sometimes, when the old pedals were not installed with enough grease on the treads, they can rust and get stuck in the cranks. Most of the time all you need is to use a lubricant, like WD-40, to get the treads moving again.

What happens if you don’t grease pedals?

Pedals don’t require grease or lubrication to the extent a bike chain or gears would since these parts are expensive and highly complex to replace. But dirt, sand and dust can conspire to wear down the threads on pedals, making it tougher to pedal smoothly and shortening the lifespan of these parts.

What can I use instead of pedal grease?

If you don’t, then any kind of grease will do, even petroleum jelly (Vaseline). A good trick for keeping the pedal/crank threads clean is to apply a small piece of tape (I use insulation tape) on the inside if the crank arm to cover the end of the pedal thread.